The MiNi Implant is used when a standard implant is too large for the surgical site. Most commonly, the MiNi is placed in the lower anterior or congenitally missing laterals.The MiNi Implant is manufactured with XPeed® S-L-A surface treatment for faster, stronger and safer integration, and is available in 2 diameters and 5 lengths. There is an 11 degree tapered connection between the abutment and the fixture, a 1.7mm hex used to engage the system for non-rotation purposes,and 1.4 diameter abutment screws to secure the abutment to the fixture.MiNi Implants are designed to be placed sub-crestal for optimal esthetic results.


MiNi, but Mighty

MiNi was designed for convenience with better reliability. When compared with company A, MiNi Ø3.0 has similar compressive strength, but Ø3.25 showed much higher strength value on the thin wall area of the fixture.


Fixture Length and Drill Marking


The platform line of the Handpiece Connector or the Ratchet Connector must be flush with the fixture platform.

When using the Ratchet Wrench, do not use an excessive torque as it can lead to a failure of internal structural damage to the fixtures. It is not recommended to exceed the maximum torque of 75N·cm.


The actual lengths of MiNiTM internal fixture is 0.5mm shorter than the depth markings of a Shaping Drill.Therefore, the fixture will be placed 0.5mm under the crest naturally.


Actual drilling depth 10.5mm

= 0.5mm subcrestal + 9.5mm actual fixture length
+ 0.5mm Y value
* Fixture Ø3.0 (Y value = 0.5mm), Ø3.25 (Y value = 0.6mm)

Surgical Drilling Sequence


Actual drilling depth 10.5mm

= 0.5mm subcrestal + 9.5mm actual fixture length
+ 0.5mm Y value


Actual drilling depth 10.6mm

= 0.5mm subcrestal + 9.5mm actual fixture length
+ 0.6mm Y value

Case Study


Fig 1. Preoperative panoramic radiograph and intraoral photos. The ridge was atrophied due to long-term absence of teeth.


Fig 2. Flap was elevated and two osteotomy sockets were made for 3.0mm MiNi fixtures. There was enough bone left in labio-lingual area for slim fixture.


Fig 3. Two 3.0 x 15.0 mm MiNi implants were placed with excellent stability. GBR was not required.


Fig 4. Two piece EZ Post were connected to make temporary prosthetics for immediate provisionalization.


Fig 5. Flap was sutured and EZ Posts were milled for better path.


Fig 6. Provisional restoration was made chair side. Due to the smaller diameter of fixture and abutment, the prosthetics will have a natural emergence profile.


Fig 7. Clinical photo right after surgery.


Fig 8. Clinical photo 1 month after surgery.


Fig 9. Clinical photo after final restoration.

Contact Us

We're not around right now. But you can send us an email and we'll get back to you, asap.

Not readable? Change text. captcha txt

Start typing and press Enter to search